2021 Busted Knuckle Ride Rear Steer Supercharged
Listing Title
2021 Busted Knuckle Ride Rear Steer Supercharged
Description
2021 Busted Knuckle Ride Rear Steer Buggy built by Nick Nelson Motorsports
Crate LT5 from GM- 800 HP stock on pump gas with their GM computer and Harness. Drysump with 3 gallon Peterson tank and off-road specific baffle. Engine has roughly 100 miles on it and the whole car is the same.
Gearworks trophy truck TH400 trans and converter
Custom 3.0 coated and built bypasses from ADS with 2.5 coilovers on Eibach springs
Ron Davis built cooling system featuring a 31x19 race radiator and custom intercooler for the supercharger.
Also have Ron Davis heat exchangers on the trans and engine oil
Atlas Race t case with all the options including 1480 flanges and HD input/output, 3.0 ratio
1480 .250 wall Adams driveshafts with flanges at the t-case to make changes easier.
1550 40 spline axles front and rear with a spare for each axle In the car included.
New gears in both axles, 5.38 ratio with a spare set from Yukon
Rockford Fosgate head unit with 2 Moto can speakers on the cage
Rugged radio and intercom
KC Flex 4 front lights, flex corner lights, and cyclone rock and interior lights
Weldon 1000 HP fuel pump w/post filter. Holley hydromat in the tank
All the chassis wiring is sealed in Raychem just like my trophy truck and U4 cars. Engine harness and computers are GM Performance
Switch Pros 12 switch key pad for chassis power control
Master battery shutoff
Has a key for security to power up buggy
Trophy Truck steering pump
Electric auto center rear steer control
20” dirty life beadlocks
42” Nitto Sticky KOH Trail Grapplers
I have spare driveshafts front and rear, 1 set of Yukon gears that fit front or rear, and I spare of each axle in the car and 2 spare stub shafts, with a spare pair of the Branik super 1550 axle U-joints so you can replace any corner on the car
Custom PRP Bravo seat and PRP harnesses
I will send a new set of panels with the car at purchase as well.
Spare accessories belt and spare 11 rib blower belt
Front and rear axles are Busted Knuckle as well. 14 bolts, 4” .250” wall tubes with Reid knuckles and PSC rams. Axles and i joints listed above.
GM makes a smaller supercharger pulley and an E85 tune that I believe makes right at 1000 hp if you want to get crazy.
No corners cut, best of everything
Crate LT5 from GM- 800 HP stock on pump gas with their GM computer and Harness. Drysump with 3 gallon Peterson tank and off-road specific baffle. Engine has roughly 100 miles on it and the whole car is the same.
Gearworks trophy truck TH400 trans and converter
Custom 3.0 coated and built bypasses from ADS with 2.5 coilovers on Eibach springs
Ron Davis built cooling system featuring a 31x19 race radiator and custom intercooler for the supercharger.
Also have Ron Davis heat exchangers on the trans and engine oil
Atlas Race t case with all the options including 1480 flanges and HD input/output, 3.0 ratio
1480 .250 wall Adams driveshafts with flanges at the t-case to make changes easier.
1550 40 spline axles front and rear with a spare for each axle In the car included.
New gears in both axles, 5.38 ratio with a spare set from Yukon
Rockford Fosgate head unit with 2 Moto can speakers on the cage
Rugged radio and intercom
KC Flex 4 front lights, flex corner lights, and cyclone rock and interior lights
Weldon 1000 HP fuel pump w/post filter. Holley hydromat in the tank
All the chassis wiring is sealed in Raychem just like my trophy truck and U4 cars. Engine harness and computers are GM Performance
Switch Pros 12 switch key pad for chassis power control
Master battery shutoff
Has a key for security to power up buggy
Trophy Truck steering pump
Electric auto center rear steer control
20” dirty life beadlocks
42” Nitto Sticky KOH Trail Grapplers
I have spare driveshafts front and rear, 1 set of Yukon gears that fit front or rear, and I spare of each axle in the car and 2 spare stub shafts, with a spare pair of the Branik super 1550 axle U-joints so you can replace any corner on the car
Custom PRP Bravo seat and PRP harnesses
I will send a new set of panels with the car at purchase as well.
Spare accessories belt and spare 11 rib blower belt
Front and rear axles are Busted Knuckle as well. 14 bolts, 4” .250” wall tubes with Reid knuckles and PSC rams. Axles and i joints listed above.
GM makes a smaller supercharger pulley and an E85 tune that I believe makes right at 1000 hp if you want to get crazy.
No corners cut, best of everything
Mileage
100 miles
Engine Cylinders
8
Fuel
Gas
Body Style
Buggy
Doors
N/A
Posted
Sep 05, 2022
Country
United States
State
Nevada
City
Las Vegas
ZIP code
89130
Front Locker
Spool
Rear Locker
Spool
Year
2021
Other Features
- Beadlock Wheels
- Winch